This is my first time with dentium super line. I place a implant 4.0x10, but the cover screw is not fully seated, because the torque of the implant was minimal. Should i be concerned?
I doubt it will be an issue as it relates to the success or failure of integration but I would be concerned about the quality control of the product you are using. I have never seen a brand new cover screw from the original package fail to fully seat into the fixture that it was packaged with. A well timed and properly machined cover screw, even from a doppelganger outfit, should thread passively until fully seated unless this particular system has incorporated some sort of friction fit into the cover screw which makes no sense… Most likely a quality control issue from the source.